Electrical Connection; Installation; Operation And Use - DeLonghi Mod. A Instruction

GB

ELECTRICAL CONNECTION

- Before plugging into the mains, make sure the voltage of your mains supply corresponds to
the V value indicated on the appliance and that the socket and power line are appropriate
for the load required.
- Certain models are without plug. To connect to the mains electricity supply, contact a quali-
fied electrician only.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC AND D. M. 476/92 ON
RADIO INTERFERENCE SUPPRESSION.

INSTALLATION

The appliance must always be used in the vertical.
Models with towel dryer rail (Model A)
These models can only be used fixed to the wall. To install, proceed as follows:
If the appliance is used in a bathroom, to avoid all risk, it must be installed as shown in fig. 6. If
installed in another room, respect the minimum distances shown in fig. 7.
The wall mounting kit includes.
1 bracket
2 x screws
2 x anchors (0. 6x30)
To mount, proceed as follows:
1. Remove the bracket on the back panel by pulling downwards.
2. Choose where you want to install the appliance, making sure that:
a. The plug and socket are easy to reach after installation.
b. Neither power cables or tubes can be damaged.
c. The appliance is a safe distance from curtains or inflammable material.
Note the minimum distances specified in figure 6.
3. Before drilling the wall, mark the exact points as shown in fig. 2.
4. For brick walls, use a 6 mm concrete bit. Drill the holes and insert the anchors supplied. (For
plasterboard or false walls, you should locate the wooden uprights and use 6 mm wood
screws directly into the wood or use specific anchors.
For any other type of wall, seek the advice of a specialist).
5. Fix the bracket with the two screws provided (fig. 2).
Attach the appliance to the top and bottom hooks of the bracket, then push it gently down-
wards.
2.Models with pedestal (Model B)
Models with pedestal (H) can be used either as portable appliances with the pedestal attached
or wall-mounted without the pedestal.
To remove the pedestal (H), press the two tabs on the back of the base and at the same time
push the heater forwards and lift the appliance up. The two tabs are identified with the word
"PUSH" (fig. 4/5). If you wish to wall-mount the appliance, follow the description for models
with towel dryer rail.

OPERATION AND USE

1. Make sure the appliance is off before plugging into the mains
2. Turn the appliance on by placing the thermostat (E) in the maximum position and the function
selector (C) in one of the following positions:
- Summer mode (fan only): turn the function selector (C) to the
- Min power operation: turn the function selector (C) to position 1. The red light comes on.
- Max power operation: turn the function selector (C) to the "2" position.
- To turn the appliance off: turn the function selector to the " " position.
Adjusting the thermostat (E)
When the room has reached the required temperature, turn the thermostat slowly anticlockwise
until the light goes out and no further.
The thermostat will automatically maintain the temperature set and keep it constant.
Frost prevention mode
With the thermostat dial at minimum
room temperature at about 5°C, preventing freezing with minimal energy consumption.
8
/1/2.
and the function selector on "2", the appliance maintains
position.