Installation - Rheem Electric Domestic Water Heater Installation And Owner's Manual

INSTALLATION

THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING
The installation must comply with the requirements of AS/NZS 3500.4,
AS/NZS 3000 and all local codes and regulatory authority requirements. In New
Zealand, the installation must conform with the New Zealand Building Code.
All packaging materials must be removed from the water heater prior to its
installation. This includes the removal of the cardboard base of the carton from
the underside of the water heater.
WATER HEATER LOCATION
This water heater is suitable for either outdoor or indoor installation (a model
with a supply cord and plug is suitable for indoor installation only). Whether
located outdoor or indoor, the water heater should be installed close to the
most frequently used outlet and its position chosen with safety and service in
mind.
Clearance must be allowed for
servicing of the water heater. The
water heater must be accessible
without the use of a ladder or scaffold.
Make sure the temperature pressure
relief valve lever is accessible and the
front cover, thermostat, heating unit
and if fitted, the side cover and
temperature limiting valve can be
removed for service.
You must be able to read the information on the rating plate. If possible leave
headroom of one water heater height so the anode can be inspected or
replaced. Remember you may have to take the entire water heater out later for
servicing.
It is recommended the water heater be installed at ground or floor level and
must stand vertically upright. The base of the water heater is made of corrosion
resistant material, and it may be placed directly in contact with the supporting
surface. It is not necessary to allow for free air circulation under the base of the
water heater.
Note: The water heater should not be placed in direct contact with a concrete
surface that is less than two months old and not fully cured as this may attack
the metal coating of the water heater base. A moisture barrier should be used
between the two surfaces in this instance.
18