BenQ T420 User Manual page 39

Sets the display to enter the power saving mode when there is no signal
Power
detected.
Save
• Eco: All source can enter the power saving mode, but only a VGA signal can
wake up the display or you have to press the power button to wake up the
display when other source is connected.
• Standard: All source can enter the power saving mode and wake up the
display.
• Off: If no source is detected, the backlight will continue on.
• VGA Only: Only the VGA signal can enter the power saving mode and wake
up the display.
Assigns an ID number for the current display when multiple displays are
Set Monitor
connected.
ID
Automatically displays swift moving patterns every 10 seconds to prevent image
Image
retention on the screen.
Retention
Automatically optimizes image display for the VGA input.
Auto
Adjustment
• Reset User Default: Resets all OSD settings (except the Language setting)
Advanced
to the factory settings.
• OSD Info Box: When turned ON, the display will always show the current
input source and resolution onscreen. Select OFF to show the information
box onscreen only when you press
• Status
- Thermal: Shows current temperature inside the display.
- Ambient Light: Shows current ambient brightness around the display.
- 5V Detect: Shows the current 5V voltage detection result.
- 12V Detect: Shows the current 12V voltage detection result.
- Operating Time: Shows the time elapsed since the display was last
- FW Version: Shows the current firmware version.
- Input Source: Shows the current input source and its resolution.
Serial can bring any mode out of the power savings.
turned on. D=Day, H=Hour.
The OSD (On-Screen Display) menu
on the remote control.
INFO
39