Compass Zone Adjustment Using Mirror Mounted Compass Reset Button; Compass Calibration Adjustment Using Mirror Mounted Compass Reset Button - Ford Explorer 2009 Owner's Manual

Driver Controls
Compass zone adjustment using mirror mounted compass reset
button (if equipped)
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Locate the reset button on top of
the compass sensor mounted behind
the mirror.
4. Press and hold the reset button on the compass module for
approximately four seconds until COMPASS ZONE XX appears in the
message center display.
5. Continue to press the reset button until the correct zone appears in
the message center display.
6. After four seconds ZONE XX IS SET will appear in the message center
display.
7. The display will return to normal operation. The zone is now updated.
Compass calibration adjustment using mirror mounted compass
reset button (if equipped)
Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all
vehicle doors are shut.
1. Start the vehicle.
128
3 2 1
4
5
6
15
14
13
12
7 8 9 1011