Setting Up A Responder; Setting Up An Initiator; Running The Test - SMC Networks SMC9432BTX User Manual

Setting Up a Responder

1. Run EZStart.
2. Select "Custom" from the EZStart main screen.
3. Select "Two Node." The "Two-Node Selection" screen appears.
4. Select "Responder." The "Respond To Test Messages" screen
appears.
The computer is ready to receive and retransmit messages. The
numbers in the "Frames Received" and "Frames Transmitted"
fields will be dynamically updated once the "Initiator" begins the
test.
Note: Repeat this procedure for all computers you wish to set up
as Responders.

Setting Up an Initiator

1. Run EZStart.
2. Select "Custom" from the EZStart main screen.
3. Select "Two Node."
4. Select "Initiator." The "Initiate Test Messages" screen appears.
Note: You can configure several Initiators, which can all send
frames to a single Responder.

Running the Test

1. From the "Initiate Test Messages" screen, use one of the
following procedures to select a Responder.
K
Select "Find Responder" to have EZStart choose the first
Responder it finds. (Skip ahead to Step 2.)
T N
ESTING THE ETWORK
C
ARD
4-3