Ford Diesel 2011 Supplement Manual page 84

Scheduled Maintenance Guide
Sustained high-speed driving at Gross Vehicle Weight Rating (maximum
Every 15,000 miles (24,000 km),
6 months, 600 engine hours or as
indicated by message center
Every 15,000 miles (24,000 km) or
Every 30,000 miles (48,000 km) – Replace wheel bearing grease and grease seals if
Every 50,000 miles (80,000 km) – Change rear axle fluid (if equipped with a Dana rear
Every 60,000 miles (96,000 km) or
2,400 engine hours
Perform the services noted in the preceding table at the specified
time/mileage (km) period either within 3,000 miles (4,800 km) of the
OIL CHANGE REQUIRED message appearing in the message center or
when the time/mileage (km) reading indicates service is due.
Example #1: The OIL CHANGE REQUIRED message comes on at
19,751 miles (31,786 km); perform the 22,500 mile (36,000 km) fuel
filter replacement.
Example #2: The OIL CHANGE REQUIRED message has not come on
but the odometer reads 22,500 miles (36,000 km); perform the fuel filter
replacement. (i.e., Intelligent Oil Life Monitor™ was reset at 15,000 miles
[24,000 km].)
Note: When adding coolant additive, do not exceed the specified
maximum of 48 fl. oz. (1.4L). Operating the engine with excessive
coolant additive may cause overheating which could lead to severe
permanent engine damage.
Note: After initial coolant flush and fill at 60,000 miles (96,000 km) or
2,400 engine hours, flush and fill every 45,000 miles (72,000 km) or
1,800 engine hours thereafter.
84
2011 Diesel (eco)
Supplement, 5th Printing
USA (fus)
loaded weight for vehicle operation)
As required – Change engine oil and filter as indicated by message
center and perform services listed in the scheduled
maintenance chart
– Replace engine- and frame-mounted fuel filters
– Inspect concentration (freeze-point protection) and
additive strength (corrosion inhibitor); add engine coolant
800 engine hours
additive, if required
non-sealed bearings are used (2WD vehicles)
axle; some F-350s, all F-450/550s)
– Change transfer case fluid (4WD vehicles)
– Flush and refill engine coolant; do not add engine
coolant additive