Table of Contents
Advertisement
13
13
Finishing
A. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances to combustibles as specifi ed. Framing or fi nishing
material closer than the minimums listed must be construct-
ed entirely of noncombustible materials (i.e., steel studs,
concrete board, etc).
Mantels
Note: All
measurements
in inches.
9
8
7
6
13-1/4
5
12-1/2
4
11-3/4
3
11
10-1/4
9-1/2
8-3/4
Measured from top of fireplace opening (in inches)
Figure 13.1 Minimum Vertical and Maximum Horizontal
Dimensions
Combustible Mantel Legs/Wall Projections
Top of
Appliance
A 2 in. (51 mm) min.
from fireplace opening
to perpendicular wall
Figure 13.2 Mantel Leg or Wall Projections (Acceptable on both
sides of opening)
30 in. minimum
to ceiling
18
17
16
15
20
14
19-1/4
13
18-1/2
12
17-3/4
11
17
10
16-1/4
15-1/2
14-3/4
14
Drywall
A
Mantel Leg or
Perpendicular Wall
Heatilator • Eclipse • 4049-229 Rev F • 11/08
B. Facing Material
•
Metal front faces may be covered with non-combustible
materials only.
•
Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers or doors,
or access for service.
•
Facing and/or fi nishing materials must never overhang
into the glass opening.
•
Observe all clearances when applying combustible
materials.
•
Seal joints between the fi nished wall and appliance top
and sides using a 300 °F minimum sealant. Refer to
Figure 13.3.
WARNING! Risk of Fire! DO NOT apply combustible ma-
terials beyond the minimum clearances. Comply with all
minimum clearances to combustibles as specifi ed in this
manual. Overlapping materials could ignite and will inter-
fere with proper operation of doors and louvers.
Finish wall material may be
combustible - Top and Sides
0 in.
High Temperature Sealant (300° F/149° C min.)
Top and Side Seal Joint
Figure 13.3 Noncombustible Facing Diagram
0 in.
0 in.
45
Advertisement
Table of Contents
