Electrical Connection (U.k. Only) - DeLonghi TOWER CERAMIC HEATER Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Tensione

vedi targa caratteristica

potenza

Voltage

Wattage

Tension

voir plaquette données

puissance

Spannung

Leistung

Spänning

Effekt

Tension

véase placa de características

Potencia

Voltagem

ver placa de especificações

Potencia

Tav s h

blev p e pinakiv d a me carakthristikav

Iscuv "

Spænding

effekt

Spänning

effekt

A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug

should be cut off from the mains lead, and an appropriate plug fitted, as below.

WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket

elsewhere in the house as this could cause a shock hazard.

With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp

Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement

fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that

as marked on the base of the plug.

If your appliance is not fitted with a plug, please follow the instructions provided below:

The wires in the mains lead are coloured in accordance with the followin code:

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying

the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which si marked with the letter L or coloured red.

See rating label

siehe Typenschild

zie plaatje

se typepladen

se märkplåt