Safety Information - Vector START-IT Owner's Manual

Be sure to read and understand all WARNINGS and CAUTIONS before using this product. Please
read this guide carefully before use to ensure optimum performance and avoid damage to the
system or items that you are using it with.
WARNINGS:
1) When working with lead acid batteries, always make sure immediate assistance is
available in case of accident or emergency.
2) Always use protective clothing and eyewear when using this product, contact with battery
acid may cause blindness and/or severe burns. Be aware of first aid procedures in case
of accidental contact with battery acid.
3) There is a risk of explosive gases being released when lead acid batteries are being
charged or discharged. Failure to follow instructions may cause property damage,
explosive hazard, and/or personal injury.
4) Make sure the safety switch is off before connecting battery clamps to discharged battery.
5) When charging unit from a 110/120 volt AC electrical outlet, in any wet or damp area,
make sure that the outlet used is protected by a ground fault interrupt (GFCI) outlet.
6) When charging the unit near water, do not allow the electrical cords and outlets to
get wet; electrical shock could result.
7) Jump-start procedures should only be performed in a safe, dry, well-ventilated area.
8) Always store battery clamps in built-in holsters when not in use. Never touch battery
clamps together - this can cause dangerous sparks, power arcing, and/or explosion.
9 When using this unit in proximity to the vehicle's battery and engine, stand the unit on a
flat, stable surface, and be sure to keep all clamps, cords, clothing, and body parts away
from moving vehicle components.
10) Do not wear vinyl clothing when jump-starting a vehicle-friction can cause dangerous
static electricity sparks. Remove all jewelry or metal objects that could cause short circuits
or react with battery acid.
11 Always disconnect the negative (Black) jumper cable first: followed by the positive (Red)
jumper cable.
12) Never allow red and black clamps to touch each other or another common metal
conductor - this could cause damage to the unit and/or create sparking/explosion
hazard. Always store battery clamps in built-in holsters when not in use.
13) Do not expose battery to fire or intense heat as it may explode. Before disposing of the
battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
14) Do not smoke, use matches or cigarette lighters while working on a vehicle's battery
system.
17) Keep unit out of reach of children (whether stored, or in use)!
2

SAFETY INFORMATION

Save these instructions
WARNING STATEMENTS IDENTIFY CONDITIONS OR PRACTICES
THAT MAY RESULT IN PERSONAL INJURY OR LOSS OF LIFE.