Replacing The Centre Belt - Husqvarna R 418Ts Operator's Manual

5 Remove the cooling fan, it is held in place by a nut.
6 Pull the belt off of the pump's pulley.
7 Pull the belt off of the engine's pulley and move it under
the engine belt pulleys.
8 Pull out the belt through the opening under the pivot
bearing and past the belt tensioner's disc.
Assembly
1 Pull the belt through the opening under the pivot bearing
and on the outside past the belt tensioner's disc.
2 Pull the belt under the engine belt pulleys and fit it on the
engine belt pulley.
3 Fit the belt on the pump's pulley.
4 Fit the cooling fan.
5 Check that the centre belt is fitted correctly on its front
pulley and fit the centre belt on the engine's pulley.
Maintenance
6 Fit the belt guide for the centre belt.
7 Fit the spring on the belt tensioner.

Replacing the centre belt

Remove the belt guide for the centre belt.
Remove the centre belt and mount a new belt.
Fit and adjust the belt guide with the lower belt on the engine
belt pulley.
Check and adjust the belt tensioner. This is especially
important when fitting a new belt.
– 29
English