Specifications - Cisco WAP121 Datasheet

Power-saving sleep mode and port control features help maximize energy efficiency.
●
Highly secure guest access enables safe wireless connectivity for visitors.
●
Support for IPv6 lets you deploy future networking applications and operating systems without
●
costly upgrades.

Specifications

Table 1 lists the specifications, package contents, and minimum requirements for the Cisco WAP121 Wireless-N
Access Point with Single Point Setup.
Table 1.
Specifications
Standards
Ports
Switch
Buttons
Cabling type
Antennas
LEDs
Operating system
Physical Interfaces
Ports
Power supply
Buttons
Lock slot
LED
Physical Specifications
Physical dimensions (W x D x H)
Weight
PoE
PoE
Peak PoE power
Network Capabilities
VLAN support
Number of VLANs
Multiple SSIDs
802.1X supplicant
SSID to VLAN mapping
Auto channel selection
Spanning tree
Load balancing
IPv6
Layer 2
© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Specifications
Description
IEEE 802.11n, 802.11g, 802.11b, 802.3af, 802.3u, 802.1X (security authentication), 802.1Q (VLAN), 802.1D
(Spanning Tree), 802.11i (WPA2 security), 802.11e (wireless QoS), IPv4 (RFC 791), IPv6 (RFC 2460)
LAN Fast Ethernet auto sensing, DC jack
Power button (on/off)
Power (on/off) push button, Reset button
Category 5e or better
Internal antennas optimized for wall, ceiling, or desktop placement
Power, WLAN, LAN
Linux
10BASE-T/100BASE-TX Ethernet, 12V DC power with support for 802.3af PoE
External 12V 0.5A DC power jack (Energy Star 2.0 compliant with Efficiency Level 5) and 802.3af PoE
Power (on/off) push button; Reset button
Slot for Kensington lock
Power, Wireless, Ethernet
4.89 x 4.89 1.38 in. (124.17 x 124.17 x 35 mm)
0.37 lb or 168 g
802.3af
6W
Yes
1 management VLAN plus 4 VLANs for Service Set ID (SSID)
4
Yes
Yes
Yes
Yes
Yes
Yes
● IPv6 host support
● IPv6 RADIUS, syslog, Network Time Protocol (NTP), etc.
802.1Q-based VLANS, 4 active VLANS plus 1 management VLAN
Page 4 of 7