Table of Contents
Advertisement
Installing the Cisco NCS 4201
Follow these steps to connect a cable to a copper Gigabit Ethernet port:
Step 1
Confirm that the chassis is powered off.
Step 2
Connect one end of the cable to the Gigabit Ethernet port on the chassis.
Step 3
Connect the other end to the BTS patch or demarcation panel at your site.
Connecting Cables to SFP Modules
For information on connecting cables to Cisco optical and Ethernet SFP interfaces, see:
Guides.
Connector and Cable Specifications
For more information on cable specifications and pinouts, see
Connecting Cables to SFP Modules
Troubleshooting
chapter.
Cisco NCS 4201 Hardware Installation Guide
Install and Upgrade
41
Advertisement
Table of Contents
