Frigidaire FFLE2022MW1 Installation Manual page 3

Please r eadallinstructions b efore using this
appliance.
Recognize safety symbols, words and
labels
Safety items throughout this manual are labeled
with a WARNING or CAUTION based on the risk
type as described below:
Definitions
This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
DANGER indicates an imminently hazardous
situation which, if not avoided, will result in death
or serious injury.
WARNING indicates a potentially hazardous
situation which, if not avoided, could result in
CAUTION indicates a potentially hazardous
situation which, if not avoided, may result in
minor or moderate injury.
IMPORTANT indicates installation, operation or
maintenance information which is important but
not hazard-related.
Shipping Hardware
1::3 Foam shipping restraint (inside wash tub) removed and
stored
1:3 Shipping bolt (underneath appliance) removed and stored
Leveling
1::3 Laundry Center is level, side-to-side and front-to-back
I:3 Cabinet is setting solid on all corners
Water Supply
1:3 Rubber washers (shipped in tub) are installed in NEW inlet
hoses (shipped in tub)
1:3 HOT supply is connected to HOT inlet and COLD supply is
connected to COLD inlet
1:3 HOT and COLD water supply turned on
1:3 No leaks present at water supply connections or appliance
inlet connections - recheck in 24 hours
Drain
1:3 Stand pipe or wall drain height minimum 33"
1:3 Drain hose secured in place with cable tie (shipped in
drum)
Exhaust Venting
1:3 Free-flowing, clear of lint buildup
1:3 4 inch (102 mm) rigid or semi-rigid ducting of minimal
length and turns
1:3 NO foil or plastic venting material
1:3 Approved vent hood exhausted to outdoors
Gas Supply (Gas Dryer)
1:3 Manual shutoff valve present in supply
1:3 All connections sealed with approved sealer and wrench
tight
1:3 Conversion kit for LP system
1:3 Gas supply turned on
1:3 No leaks present at all connections -
check with soapy water, NEVER check with flame
240v Electric Supply (Electric Dryer)
1:3 Approved NEMA 10-30R or 14-30R service cord with all
screws tight on terminal block
1:3 Approved strain relief installed
1:3 Terminal access cover installed before initial operation
Electrical Power
1:3 House power turned on
1:3 Laundry Center plugged in
Final Checks
D Installation Instructions and Use and Care Guide
read thoroughly
1:3 Water enters drum when cycle starts with lid lowered.
Dryer door latches and drum tumbles when cycle starts.
1:3 Registration card sent in