Electronic Control - Danby DPA120B1WB Owner's Use And Care Manual

Features

ELECTRONIC CONTROL

INSTRUCTIONS
POWER button
1
Turns power on/off.
2
SLEEP button
Used to initiate the SLEEP operation.
3
FAN button
Controls the fan speed. Press to select the fan speed in two steps:
LOW and HIGH. The fan speed indicator light illuminates under differ-
ent fan speed settings.
ION button(select models)
Press the ION button, the ion generator is energized and begins to
remove pollen and impurities from the air, and trap them in the filter.
Press it again to stop the function.
4 UP (+) and DOWN (-) BUTTONS
Used to adjust (increase/decrease) temperature settings (1°C/2°F
increments) in a range of 17°C(62°F) to 30°C(88°F) or the TIMER set-
ting in a range of 0~24hrs. The control is capable of displaying
temperature in degrees Fahrenheit or degrees Celsius. To toggle from
one to the other, press and hold the Up and Down buttons at the same
time for 3 seconds.
MODE select button
5
Selects the appropriate operating mode. Each time you press the but-
ton, a mode is selected in a sequence that goes from AUTO, COOL,
DRY, FAN and HEAT(select models only). The mode indicator light
illuminates depending on the mode settings.
TIMER button
6
Used to initiate the AUTO ON start time and AUTO OFF stop time pro-
gram, in conjuction with the up (+) & down (-) buttons.
SWING button
7
(select models only) Used to initiate the Auto swing feature. When
operating press the SWING button to stop the louver at the desired
angle.
8 LED DISPLAY
Shows the set temperature in °C or °F and the Auto-timer settings.
While on DRY and FAN modes, it shows the room temperature.
Error codes:
E1 - Room temperature sensor error-Unplug the unit and plug
it back in. If error repeats, call for service.
E2 - Evaporator temperature sensor error- Unplug the unit and
plug it back in. If error repeats, call for service.
E3 - Condenser temperature error - Unplug the unit and plug it
back in. If error repeats call for service.
E4 - Display panel communication error - Unplug the unit and
plug it back in. If error repeats call for service.
P1 - Bottom tray is full - Connect the drain hose and drain the
collected water away. If error repeats, call for service.
7