Healthrider C515e HREL3006.0 User Manual page 8

8. Identify the Left Pedal Leg, which is marked with a
"Left" sticker. Attach a Pedal Bracket (15) to the Left
Pedal Leg with two M8 x 65mm Button Bolts (89), two
M8.5 Washers (53), and two M8 Nylon Locknuts (46).
Identify the Left Pedal (13). Attach the Left Pedal to the
Left Pedal Leg (14) with two M8 x 50mm Button
Screws (82), two M8 Split Washers (58), and two M8.5
Washers (53).
Attach the Right Pedal (not shown) in the same
way. Make sure that both Pedals are in the same
position.
9. Apply a generous amount of grease to the Left Crank
Arm (36) and a Large Wave Washer (20). Then, slide a
Pedal Leg Spacer (88) and the Left Pedal Leg (14)
onto the Left Crank Arm.
Attach the Left Pedal Leg (14) to the Left Crank
Arm (36) with an M8 x 25mm Patch Screw (22), an
M8.5 Washer (53), and the Large Wave Washer (20).
10. Hold the lower end of the left Handlebar Leg (79) inside
of the Left Pedal Leg (14). Apply a small amount of
grease to an M10 x 52mm Bolt Set (27). Attach the left
Handlebar Leg to the Left Pedal Leg with the Bolt Set.
Do not overtighten the Bolt Set; the left Handlebar
Leg must be able to pivot freely.
Attach the right Handlebar Leg (not shown) to the
Right Pedal Leg in the same way.
11. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip-
tical exerciser.
8
15
46
9
10
79
Grease
27
14
8
13
89
53
14
53
58
58
82
Grease
14
88
36
20
22
53
Grease
27