Healthrider C515e HREL3006.0 User Manual page 12

HOW TO USE A PRESET PROGRAM
1
Turn on the console.
See step 1 on page 11.
2
Select a preset program.
To select a preset
program, press
the Program but-
ton repeatedly
until the number 1,
2, 3, 4, 5, 6, 7, or
8 appears along
the left side of the display. When you select a
preset program, the display will show the length
of the program.
3
Begin pedaling to start the program.
Each preset program consists of several one-
minute segments. One resistance level and one
target pace are programmed for each segment.
At the end of each segment, the resistance level
will flash in the display for a few seconds. The
resistance of the pedals will then automatically
change to the resistance level programmed for
the next segment. Note: If the resistance level is
too low or too high, you can override it by press-
ing the Increase and Decrease buttons. However,
when the current segment ends, the resistance
will automatically change to the resistance level
programmed for the next segment.
During the program, the pace guide will prompt
you to increase or decrease your pedaling pace.
When one of the two lower indicators lights,
increase your pace; when one of the two upper
indicators lights, decrease your pace. When the
center indicator lights, maintain your current
pace. Important: The pace guide is intended
only to provide a goal. Make sure to pedal at a
pace that is comfortable for you.
The display will show the time remaining in the
program. If you stop pedaling for a few seconds,
the program will pause and the time will flash in
the display. To restart the program, simply resume
pedaling.
4
Follow your progress with the display.
See step 4 on page 11.
5
Measure your heart rate if desired.
See step 5 on page 11.
6
Turn on the fan if desired.
See step 6 on page 11.
7
When you are finished exercising, the con-
sole will turn off automatically.
See step 7 on page 11.
12