Belkin Wireless G Ethernet Adapter User Manual page 16

Connecting the Adapter Using the Setup Wizard Connecting the Adapter Using the Setup Wizard
b. Subnet Mask:
The Adapter's Subnet Mask must be the same as your network's
subnet mask.
c. Router:
Enter the IP address of your network's gateway (also known as
router).
a
b
c
11.
From the Encryption drop-down menu, select "Disabled", "64-bit",
or "128-bit" according to your wireless network's setting. Select
"Disabled" if you have not configured your wireless network to use
encryption. All wireless devices on your network must share the same
network key. Click "Next" to continue.
a. Encryption:
There are two types of encryption to choose from: 64-bit and
128-bit. Using encryption will make your network more secure,
but will slow down the network performance. Although network
performance will be reduced, it is likely the change will not be
detectable to users of the network.
b. Network Key:
Enter a network key only if you have encryption enabled in your
wireless network. Type your WEP key in the Network Key box
using passphrase or hex key format. All wireless devices on your
network must share the same network key.
14 14 14