Dirt Devil Vacuum Cleaner Owner's Manual page 11

WARNING: TO REDUCE THE RlSK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906,13.0 volts. For bulb replacement call 1-800-321-1134
or your local auto parts store.
TOOL REQUIRED: FLATHEAD SCREWDRIVER
Lean cleaner handle back.
Pull bulb out of socket to Secure the headlight lens by
Remove the two (2) screws remove. Do NOT twist. replacing the two (2) screws.
located on either side of the Gently push bulb into socket
headlight lens. to replace.
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
DEBRIS REMOVALIHOSE
Check to see if dirt cup is full; empty if needed.
Plug cleaner in and check to see if there is any
suction at end of hose (Diagram 1). If there is suction
at end of hose, move on to Diagram 4. If there is
no suctionat the end of hose. Clear dirt path window
and lower hose. Follow these steps: 1. Remove hose
from upper hose inlet (Diagram 2) by reversing Step
1, Page 6, under heading "Upper Tool Caddy (Back)."
2. Unwrap hose from caddy. Remove obstruction. 3.
Remove hose from clear dirt path window (Diagram
3) by reversing Step 2, Page 7, under heading
"Secure Side Hose". Remove obstruction.
DEBRIS REMOVAL1 DEBRIS REMOVAL/TURBO TOOL"
NOZZLE GUARD
Remove nozzle guard (see Rotate locking ring 180"
Pivot lower housing and
Diagram 1) by removing the and turn turbo tool over.
remove clog.
five (5) screws. Look for any
obstructions and remove.
11