Table of Contents
Advertisement
Using Your Radio
• The radio updates the location based on the FIPS code programmed and
shows the location name. If the new FIPS code does not match any county,
displays followed by the code programmed instead of a county name.
FOUND
Programming Alerts
Your radio has a large number of alerts turned on by default. For a full list of NWS
alerts and default settings, see page 12.
To change alert settings:
1. Press MENU and then or to select
SET ALERTS?
2. Press SELECT and then or to select an alert.
3. Press SELECT again and then or to select
or
ALERT ON
4. Press SELECT to confirm the selection.
5. Press MENU to exit.
Restoring Factory Default Settings
1. Unplug the AC adapter and remove the batteries.
2. Press and hold WEATHER/SNOOZE, and at the
same time plug the AC adapter in or install the
batteries. When
3. Press MENU to clear the memory and restore factory settings.
displays. Wait 5 to 10 seconds until
4. Unplug and then plug the AC adapter (or remove the batteries and then
install them). Your radio is restored to factory default settings.
Using Your Radio
Viewing Alerts
When an alert is received, the alert description displays. If multiple alerts are
received, press to view them in the order they were received. The description
of a newly received alert displays immediately. Your radio can memorize up to
four different alerts for you to cycle through. For example, if three alerts are
received, they display in turn in this way:
.
.
ALERT OFF
displays, release WEATHER/SNOOZE.
USER SETUP
displays again.
USER SETUP
10
NOT
DEFAULT
Hide quick links:
Advertisement
Table of Contents
