How To Get Started - iRobot Scooba 200 Series Ownsers Manual

how to get started

Charge scooba
1 before using scooba
for the first time, insert
the included battery.
set up scooba
1 slowly add warm
water into fill port.
open both fill and
eMPtY ports so the
bladder can fully
expand.
ensure the charger jack
door is closed.
ready to go
1 first, sweep up large debris and
remove clutter and lightweight
rugs from area to be cleaned.
empty and Clean scooba
1 at the end of the cycle, empty
and thoroughly rinse both tanks
with water.
2 Place scooba on the storage
mat (to protect the brushes)
and plug in scooba.
2 add scooba hard
floor Cleaner.
(1 packet or 1/2 capful)
2 Place scooba on the floor
and press the power button
to turn on scooba.
2 remove bottom plate. rinse and remove
all debris from brushes and squeegee.
3 Charge scooba until the green light
on the charger is solid. (up to 8 hours)
3 firmly close
fill and
eMPtY ports
until sealed.
3 Press and release the
Clean button to begin
the full cleaning cycle.
for short cycle, press
and hold until second
song starts.
3 Clear any debris on scooba before
replacing bottom plate. if necessary,
remove and replace tires.
global.irobot.com
2