Table of Contents
Advertisement
troubleshooting
scooba will tell you if something is wrong with a two-tone "uh-oh" sound and a series of beeps and light
blinks. Count light blinks or beeps and refer to the chart below to identify and resolve the problem.
to repeat error blinks and beeps, tap scooba's bumper. if the problem persists, contact irobot
customer support.
Number of
Likely cause
beeps/blinks
after uh-oh
0 (error leD
fill tank is empty
on solid)
1
scooba is on a cliff
Cliff sensors are dirty
Cliff sensor malfunction
2
scooba is stuck
3
bumper problem
4
left or right wheel malfunction inspect and clean scooba's wheels and press clean.
5
scooba's vacuum tubes are
clogged or hydro-locked
6
Pump malfunction
7
Vacuum malfunction
Charger Light
Charger is plugged in and
connected to scooba, but
charger light is off
9
irobot scooba 200 series owner's Manual
What to do
fill tank with water and cleaning solution and press Clean.
Move scooba to a clear area and press clean.
Clean the three cliff sensors with a cotton swab and press clean.
Cliff sensors are located in the bumper and are accessed by turning scooba over.
Contact irobot customer care.
Move scooba to a clear area and press clean.
if scooba is stuck near a Virtual wall, move scooba away from the Virtual
wall and press clean.
tap the bumper to ensure that it moves in and out. remove any visual
debris from the bumper edges and press clean.
remove scooba's bottom plate and clear debris from vacuum tubes.
replace bottom plate and move scooba to a clear area and press Clean.
(note: scooba is not intended to clean up large spills.)
Contact irobot customer care.
Contact irobot customer care.
Likely cause
What to do
no power at wall
Disconnect charger from outlet and from scooba. wait 5 seconds and plug
outlet or charging
charger into outlet and directly into scooba. if the charger light does not turn
error
on, confirm power is present at the outlet by plugging in a lamp.
Advertisement
Table of Contents
