How To Get Started - iRobot Scooba 300 series Owner's Manual

How to get started

Charge Scooba
Pick Scooba up by the handle and set it down on a flat surface.
1. Press the handle down to release the tank. Remove the tank.
2. Insert the battery by aligning guide tabs and click it into place.
3. Plug in the battery charger and let the battery charge overnight
(first time only).
1
Set up Scooba
1. Once Scooba is fully charged, remove the charging plug and remove
the tank.
2. Fill the clean tank with water and optional Scooba Hard Floor Cleaner.
For a shorter cleaning cycle, put less water in the tank. Close tank caps.
3. Place the tank back in Scooba and push the tank down until it clicks
into place.
1
Ready to go!
First, sweep up large debris and then place Scooba in the middle
of the room.
• Press POWER to turn Scooba on.
• Press CLEAN to start a cleaning cycle.
Then just walk away and let your Scooba get to work (approximately 45
minutes for a full tank.)
TIP: If you wish to end a cleaning cycle early, activate the internal drying
mode first by pressing CLeAN while Scooba is cleaning. If Scooba is off,
press POWeR and then press CLeAN twice.
2
2
3
3
global.irobot.com 2