Gigabyte GA-F2A85X-UP4 User Manual page 23

RJ-45 LAN Port
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Connection/
Connection/Speed LED:
Speed LED Activity LED
State
Orange
Green
Off
LAN Port
Center/Subwoofer Speaker Out Jack (Orange)
Use this audio jack to connect center/subwoofer speakers in a 5.1/7.1-channel audio configuration.
Rear Speaker Out Jack (Black)
This jack can be used to connect front speakers in a 4/5.1/7.1-channel audio configuration.
Side Speaker Out Jack (Gray)
Use this audio jack to connect side speakers in a 7.1-channel audio configuration.
Line In Jack (Blue)
The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
Line Out Jack (Green)
The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be used
to connect front speakers in a 4/5.1/7.1-channel audio configuration.
Mic In Jack (Pink)
The default Mic in jack. Microphones must be connected to this jack.
In addition to the default speakers settings, the ~
different functions via the audio software. Only microphones still MUST be connected to the
default Mic in jack (
figuration in Chapter 5, "Configuring 2/4/5.1/7.1-Channel Audio."
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to prevent
an electrical short inside the cable connector.
Activity LED:
Description State
1 Gbps data rate Blinking
100 Mbps data rate Off
10 Mbps data rate
). Refer to the instructions on setting up a 2/4/5.1/7.1-channel audio con-
- 23 -
Description
Data transmission or receiving is occurring
No data transmission or receiving is occurring
audio jacks can be reconfigured to perform
Hardware Installation