TANDBERG 3G Gateway User Manual page 48

TANDBERG 3G Gateway User Manual
The configuration should be read from left to right as subsequent actions taken after each otter:
In Prefix/nr (remove) in Postfix(remove) Service type out Prefix/Nr (add) out Postfix
(add). The in Prefix/Nr & Postfix set will be used for matching the incoming called
number/address. The out Prefix/Nr & Postfix set will be used to construct the number/address
that will be called (if applicable).
Prefix/nr (from)
In case a number matches this prefix it will be removed. Like for example:
Prefix/Nr: 6789
Dialed number: 67890000
Number used in rest of matching process is 0000
Postfix (from)
In case a number matches this postfix it will be removed. Like for example:
Postfix: 00
Dialed number: 67890000
Number used in rest of matching process is 678900
Net type (to)
The following settings are available which can be extended in future releases:

H323

3G / H324m
Prefix/Nr (to)
This number will be put in front of a number dialed. Like for example:
Prefix/Nr: 1234
Dialed number: 4567
Number used in rest of matching process is 12344567
Postfix (to)
This number will be added after a number dialed. Like for example:
Postfix: 1234
Dialed number: 4567
Number used in rest of matching process is 45671234
Note that it is not possible to configure ISDN BRI lines for special functions like dial out only.
The gateway will automatically select a free BRI line for H323 to 3G calls and possibly block a
DiD or an IVR menu when the BRI lines have different numbers. It is therefore strongly
recommended that all ISDN BRI lines have the same number range
48