iHome iW4 Start Manual page 6

Option C - Connecting directly via Ethernet
Follow this method if you have a wired home network or prefer the performance of a direct
connection with router.
Using a Ethernet cable (not provided):
1. Press & hold the Power button (4 seconds) to power OFF the iW4 network.
2. Connect an ethernet cable to the iW4 rear ethernet port and to your router (or network).
3. Press & hold the Power button (4 seconds) a second time to power ON the iW4 network and establish a direct
ethernet connection.
Success!
Congratulations, you have successfully connected your iW4 to your wireless network. Verify that
the Network Status LED is green and that the Network Status Indicator icon shows signal
strength to confirm if the iW4 is successfully connected to a network. Keep reading on the other
side of this guide to start using AirPlay and other iW4 features.
Connected
sync
skip alarm
2 alarm alarm 1
12V 3.5A aux-in
If the Network Status LED is green, the iW4 is
connected to a network
Visit our website for additional network setup instructions: www.ihomeaudio.com/support/airplay/
Turn over for more information Turn over for more information
power
eq presets nap alarm 1 alarm 2
alarm skip
sync
network setup
status
nap presets eq
power
status network setup
If the Network Status LED is flashing red, the iW4 is not
connected to a network because, either:
- The iW4 has not been connected to a Wi-Fi network
- There is a problem with your Wi-Fi network
- Or, the iW4 is out of range
Not Connected
status
sync
skip alarm
2 alarm 1 alarm nap presets eq
power
status network setup
12V 3.5A aux-in
Network Problem?
network setup
Reset the iW4 Network:
- Press & hold the Power button (4 sec.) to turn networkOFF.
- Press & hold the Power button again to reactivate the network.
- Visit our website for additional instructions and support.
power
eq presets nap alarm 1 alarm 2
alarm skip
sync