Table of Contents
Advertisement
An optional Alpine Portable Navigation System is controllable from the
unit. For details on operation, refer to the Owner's Manual of the
Portable Navigation.
If the Built-in Dock is used:
About dockable Portable Navigation devices with this unit.
• Docking to the PMD-B100 is not possible.
• The IVA-W203 can be connected by docking with the PMD-B200 or
NVE-P1.
1
Press
on the unit.
The unit changes to the EJECT/TILT screen.
2
Touch [OPEN].
The movable monitor will open.
3
Remove the slot panel, then insert the Portable
Navigation device in the unit (See the illustration
below).
Optional Portable
Navigation
• The slot panel can be detached by placing a finger in the hole in the
center of the panel and pulling it down.
• If the face plate is attached, first remove the face plate, then the slot
panel. After removing the slot panel, reattach the face plate.
4
After inserting, touch [CLOSE] on the EJECT/TILT
screen.
The movable monitor will close.
5
Press SOURCE.
The SOURCE selection screen is displayed.
6
When the source name of [NAV.], on the SOURCE
selection screen is displayed, touch the desired
source name.
• For details on operation, refer to the Owner's Manual of the Portable
Navigation device.
Portable Navigation Slot
Removing the Portable Navigation Device
1 Press
on the unit.
The display changes to the EJECT/TILT screen.
2 Touch [OPEN] or [ ] of NAV. on the EJECT/TILT screen.
The movable monitor will open.
3 Press [ ] behind the monitor.
The Portable Navigation device is removed.
Take care when removing the optional portable navigation system, as it
may spring out strongly from the unit.
Be careful with removing the Portable Navigation System
While your vehicle is stopped, remove the navigation system by
pressing the
button with your hand in the slot of the unit, ensuring
that the navigation system does not hit your finger.
Push
49
-EN
Hide quick links:
Advertisement
Table of Contents
