Eclipse AVN2210p Owner's Manual page 4

CAUTION
● Wiring and installing this main unit requires expertise and experience. Professional
installation is recommended. Consult with your dealer or a professional installer. Incorrect
wiring may damage the main unit or interfere with safe vehicle operation.
● Use only the accessory parts as specified. Using other parts may cause damage to the main
unit or cause parts to dislodge and fall or fly off the main unit.
● Do not install the main unit in places where it may be exposed to dew condensation on
(around the air conditioning hose, etc.), come in contact with water, or in conditions of high
moisture, dust or oily smoke. If water, moisture, dust or oily smoke enters this main unit,
smoke, fires or malfunctions may result.
● Do not install in places with direct sunlight or where it will be hit directly by hot air from the
heater. This may increase the interior temperature of this main unit, resulting in fires and
malfunctions.
● Do not impede the air flow of the heat sink or vents of this main unit. Impeding the air flow will
cause the interior of the main unit to overheat, and fires may result.
● Connect as specified in the installation manual. If not connected correctly, fires or accidents
may result.
● Install wiring in a manner in which they are not pinched by movable parts such as seat rails,
and screw parts of the vehicle body. Accidents, fires and shocks may result from
disconnection and electrical shorts.
● Install wiring in a manner in which they do not make contact with metal parts. The wiring
maybe be damaged by contact with metal parts, resulting in fire and shocks.
● Avoid any contact with hot surfaces when wiring the main unit. High temperatures may
damage wiring, causing shorts, arcing and fires.
● When changing the installation location for this main unit, please consult the dealer where
you bought it for safety reasons. Expertise is necessary for removal and installation.
● Keep volume to a reasonable level so that you can hear sounds from outside the vehicle,
including warning sounds, voices, and sirens. Failure to do so may cause an accident.
● Be careful that hands and fingers are not pinched when adjusting the tilting angle or closing
display. Injuries may result.
● Do not put your hands or fingers into the disc insertion slot or USB input terminal. Injuries
may result.
● Do not touch heat dissipating parts of the main unit as burns may result.
● Volume should be set at a moderate level to avoid hearing damage when the main unit is
powered on.
● Do not operate when the sound is not being emitted properly such as distortion.
● This main unit uses invisible laser light. Do not disassemble or alter this main unit. If trouble
occurs, contact the dealer where you bought the main unit.
Altering this main unit may cause exposure to laser emissions (worsening eyesight), or
result in accidents, fires or shocks.
● If the main unit is dropped or the cosmetics appear broken, turn off the power to the main
unit and contact your dealer. If used in this condition, fires or shocks may result.
● Using the vehicle speed pulse signal, you can use the route guidance function even in the
locations where usually no guidance is given (example: in a tunnel). However, the accuracy
of the guidance is not guaranteed since the guidance is performed using the information
about road surface condition and vehicle speed.
● Precautions for PND Operation
Do not remove the SD card while operating the PND.
Turn off the power to the PND, and wait at least 3 seconds after the display goes off, before
removing the SD card. Failure to do so may cause data in the SD card to be lost or damaged.