Before Asking For Repairs - Eclipse AVN2210p Owner's Manual

Before Asking for Repairs

Slight differences in operation can sometimes be mistaken for malfunctions, so check the following
table before asking for any repairs.
CAUTION
If a problem occurs, for instance when the main unit does not respond to any button operation, or
the display does not work correctly, press the [Reset] button using a paper clip or anything similar.
Pressing the [Reset] button will delete all the entries from memory. The settings will return to those
made at the factory prior to shipment.
If the following fail to solve the problem, contact the place of purchase.
Problem
The screen is dark for a brief
period when the power is turned
on at low temperatures.
The display is distorted for a
short while after the power is
turned on.
No sound comes out.
Sound comes out of only one
side (left or right, front or back).
The sound quality does not
change even after making
adjustments.
A CD will not go into the deck.
A CD cannot be played.
Possible reason
This is a characteristic of LCDs.
This is a characteristic of LCD
backlighting.
The volume is poorly adjusted or
MUTE is on.
The music is muted when the
PND is attached to the main unit
and when:
- voice guidance is given
- talking in hands-free mode*
A speaker wire is disconnected.
Volume is poorly adjusted.
The adjusted audio quality is not
included in the radio broadcast
or disc.
The power is not turned on.
A disc is already inserted and
you are trying to insert a second
disc.
There is water condensation in
the equipment.
There is a large scratch or warp
in the CD.
The CD is very dirty.
The CD is upside down.
A non-supported type of CD has
been inserted.
Corrective action
This is not a malfunction. Wait
for a brief period.
This is not a malfunction. The
display will stabilize after a brief
period.
Turn the [VOL] rotary knob and
check the volume. Or cancel
MUTE.
This is not a malfunction. The
music can be heard again when
the voice guidance finishes or
the hands-free mode is turned
off.
Check the connections of the
speaker wires.
Check the balance and fader
adjustments.
Check by changing the radio
station or disc.
Turn the vehicle ignition switch
to [ACC] or [ON].
Eject the previously inserted CD
and insert the preferred CD.
Do not use the equipment for a
while and then try using it again.
Insert a different CD.
Clean the CD.
Insert the CD with the proper
orientation.
Insert a CD that is supported by
the deck.