Advertisement
POWER CONNECTION FOR NEGATIVE GROUND VEHICLES
Vehicle with negative ground will have the negative (-) terminal connected directly
to the frame or chassis of the veh icle.
Vehicles with positive ground will have the positive (+) terminal connected directly
to the frame of chassis of the vehicle.
DO NOT USE WITH POSITIVE GROUND SYSTEM.
Connect the Red wire (with in-line fuse holder) to the Accessory terminal on the
ignition switch of your vehicle. Make a good mechanical and electrical connection
to the frame of the vehicle for the Black (negative) wire.
IGNITION INTERFERENCE
The ignition system of automobiles may create noise that will interfere wi+h the
operation of the unit. Noise filters (optional) are available to eliminate this type of
interference.
ANTENNA COUPLING HARNESS
The antenna coupling harness is intended for use with your automobile antenna.
When it is installed, the necessity of changing over the antenna plug from the car
radio to the Programmable Scanning Monitor is eliminated.
Connecting the Antenna Harness:
Insert the plug of the sutomobile antenna into the jack of the antenna coupling
harness. Then insert one cable marked as
"AM/FM
RADIO" when comes from the
coupling harness into the antenna jack of the car radio and the other cable marked
as "SCANNER" into the antenna jack of the Programmable Scanning Monitor.
Note:
If, when using the antenna coupling harness, reception is not satisfactory we suggest
that you purchase a separate antenna for use with your Programmable Scanning
Monitor. This will
improve
your reception under weak signal conditions.
TO CAR ANTENNA
~~--r(I--~
..
~
(
J~---
~
.
+-~(
~
TO PROGRAMMABLE
SCANNING
~
MONITOR ANTENNA JACK
-5-
Advertisement
