Advertisement
•
•
•
•
• •
• •
•
AC POWER SOCKET
PROGRAM
CARD SLOT
EX
TE
RNAL
SPEAKER
JACK
GRO
UN
D
TERM
INAL
DC POWE
R SOCKET
Insert your program card into this
slot.
For programming desirable frequencies on
the program card refer to "Program Card Programming"
in the other booklet
provided and titled as "CODE BOOK",
CHANNEL SKIP BUTTONS
These
skip buttons are provided to turn each individual channel on or off. When a
button is set to the off position (button in), the corresponding channel is
sk
ipped
(by-passed)
and will not flash or receive signals in either the manual or automatic
scanning
mode.
AUTO/MANUAL
SWITCH
Auto: Set
the Aoto/Man ual switch to the AUTO position for automatic scanning.
In
addition, the receiver must be squelched ON. To squelch ON the unit, turn the
Squelch
control until all the "noise" from the speaker is eliminated and scanning
action is obtained.
Manual: Activate the channel you want to monitor and then set the
Auto/
Manua
l
switch to the MANUAL position for manual selection of the channel to be
monitored.
ANTENNA
JACK
The antenna jack may be used to connect the VHF-UHF telescop ing antenna
provided,
or for increased I istening range, outdoor-type antennas are available from
your
Sears
store.
Your choice of antenna type should be determined by location and service
conditions
under which the equipment will be used.
Various types of antennas
are available
(optional). See Sears' display.
Note:
When
installing the antenna, be sure to recheck all fittings and connectors
for
proper assebmly to avoid shorts or open
circuits.
-2-
Advertisement
