Advertisement
EXTERNAL SPEAKER JACK
You can connect an external speaker (8 ohm) to this jack for remote listening
(Built-in speaker is then disconnected automatically)
.
AC POWER SOCKET
Can accept 120V AC.
DC POWER SOCKET
Connect
the
Red wire to the Positive
(+)
side of 12V DC power supply or battery
and the Black wire to the Negative (-) side. Before attempting this, be sure to read
"Installation" instructions.
OPERATION
1. Set all CHANNEL SKIP BUTTONS to on position (button out).
2.
Turn SQUELCH CONTROL fully counterclockwise.
3. Turn power "on" by rotating VOLUME ON/OFF SWITCH clockwise.
4.
While no signal is being received, adjust SQUELCH CONTROL clockwise until
the rushing background noise stops.
Do not turn SQUELCH CONTROL any
further clockw ise than the point required to stop the background noise. To do
so will decrease the receiver's signal pick -up sensitivity.
After SQUELCH
CONTROL is adjusted properly, the receiver will now scan and operate normally
in the manual or the automatic
mode.
5. SCANNING MANUAL: Check to see that AUTO/MANUAL SWITCH is down
Then select the channel desired by pressing MANUAL CHANNEL SELECTOR
SWITCH momentarily one or more times until the desired channel is obtained.
A CHANNEL INDICATOR LIGHT will indicate th
e
channel
that
has been
activated
.
AUTO:
Check to see that AUTO/MANUAL SWITCH is up. The receiver will
automatically switch to each channel in sequence. Scanning wil
l
continue until
an activated channel is received
.
The receiver will not scan if the squelch is
decreased to the point where noise is present.
To advance from a channel that is being received the CHANNEL SKIP BUTTON
must be pushed in
.
Th is Button must then be reset to the "NOR MAL" position
to avoid skip.
If it is desired to by-pass one or more channels in the scanning sequence,
CHANNEL SKIP BUTTONS for the undesired channels should be set in the off
position (button
in).
This feature is useful when one of the channels being
received is from a continuous transmission type station such as the national
weather
service.
CHANNEL INDICATOR LIGHT only shows on the channels
where the CHANNEL SKIP BUTTON has been set in the "NORMAL" position.
-3-
Advertisement
