Rear Panel; Installation - NETGEAR WNCE4004 User Manual

Wireless HD Video and Gaming Adapter WNCE4004

Rear Panel

Figure 1. Rear panel

Installation

The Wireless HD Video and Gaming Adapter (WNCE4004) Installation Guide, included in the
package, explains how to install your Internet adapter. The steps are summarized in this
section.
1. You use a computer to set up the Internet adapter. During setup, make sure that your
computer is not connected to a router. You can restore the connection after the Internet
adapter installation is complete.
• Disconnect the Ethernet cable from your computer if you use it for a wired network
connection.
• If your computer is wirelessly connected to a network, stop your wireless connection.
2. Connect the Internet adapter.
• Use an Ethernet cable (included) to connect the Internet adapter to your computer.
• Use the power adapter to provide power to the Internet adapter. (See
page 5.)
3. Open your Internet browser. It automatically displays the setup page. If the setup page is not
displayed, type http://www.mywifiext.net as the browser address. Follow the instructions
on the setup page.
4. Disconnect the Ethernet from your computer.
5. Connect the Internet adapter to your TV, XBox, or Blu-ray player.
6. Congratulations! Your installation is complete. You can return your computer to its usual
setup and begin using the Internet adapter.
Power
Ethernet
jack
ports
Installation
Chapter 1. Getting Started
on
| 5