En•English; Customer Service - Peg-Perego Pliko Lite Instructions For Use Manual

EN•ENGLISH
• IMPORTANT: read the instructions
carefully before using the stroller. Save the
instructions for future reference.
• PEG PEREGO reserves the right to make any
necessary changes or improvements to the
products shown at any time without notice.

CUSTOMER SERVICE

If parts of the model are accidentally lost or
damaged, use only original Peg Perego spare
parts. Contact the Peg Perego Customer
Service for all repair work, replacements,
information about products, and sale of
original spare parts and accessories, at the
following:
USA:
tel.: 800.671.1701
fax: 260.471.6332
Call us toll free: 1.800.671.1701
CANADA:
tel.: 905.839.3371
fax: 905.839.9542
Call us toll free: 1.800.661.5050
www.pegperego.com
INSTRUCTIONS FOR USE
OPENING
1• Before opening the stroller remove the
two protective caps from the hooks
as shown in the figure. Otherwise, the
stroller will not open correctly.
2• To open the stroller, pull up the two
levers on the handles and
3• at the same time, lift the stroller, which
will open automatically. To make sure
that the stroller has been set up correctly,
check the two side hooks (see figure).
ASSEMBLYING THE STROLLER
4• To mount the front wheels, lower Lever
A and slip the wheels onto the axle,
as shown in the figure. Press until the
wheels click into place.
5• To mount the rear wheels, slip the wheels
onto the axle, as shown in the figure.
Press until the wheels click into place.
6• To mount the basket, slide the slots onto
the front hooks A and the rear hooks B
and C.
7• The figure shows the mounted basket.
8• The drink-holder can be attached to the
left or the right handle of the stroller,
using the two bands.
• To attach the drink-holder to the handle,
widen the band, keeping the shaped side
on the inside of the handle, in line with
the raised surface.
9• Slide the clamp in the drink-holder until
it clicks.
Do not put hot drinks in the drink-holder,
nor items weighing more than 1 kg (2.2
lbs).
HOOD
• The hood comes with a zipper, for
attaching the zip-on rain canopy or
mosquito netting (see Accessories Line).
10• To mount the hood, push the fittings
down until they click, as shown in the
figure.
11• As shown in the figure, button the hood
inside the armrest and the backrest of the
stroller.
12• To stretch out the hood, push the
coupling downward. The hood can be
reclined by following the inclination of
the backrest.
13• To remove the hood, you must unbutton
it from the stroller, loosen the couplings
and raise the tabs of the fasteners,
pushing towards the inside of the stroller.
BRAKE
14• To apply the brakes, push down with
one foot the bars on the rear wheels,
as shown in the figure. To release the
brakes, draw the bar up. Always set the
brakes on the stroller when it is not in
motion.
SAFETY BELT
15• A: Make sure that the brace is properly
inserted by pushing as shown in the
figure. B: Fasten the belt as shown in the
figure.
16• To unfasten the belt, press on the buckle
sides and pull out the waist strap.
ADJUSTING THE FOOTBOARD
17• The footboard can be adjusted to
three different positions. To lower the
footboard, pull the two small levers
downward while lowering. To lift the
footboard, pull it up until it clicks into
place.
ADJUSTING THE BACKREST
18• The backrest can be lowered to three
different positions. To lower the backrest,
pull the two adjustment levers towards
you. To raise it, pull the backrest
upwards.
SWIVELLING WHEELS
19• To make the front wheels swivel, push
down as shown in the figure. To fix the
wheels, pull up the lever.
CLOSING
Before closing the stroller, loosen the
braces if the hood is attached, and raise