Kenwood DNX7250DAB Quick Start Manual page 24

Ñ Supplied accessories
First of all, make sure that all accessories are
supplied with the unit.
1
[1]
3
[2]
5
7
[1]
9
Ñ Unit
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of
the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wire on the wiring harness.
4) Take Connector B on the wiring harness and
connect it to the speaker connector in your
vehicle.
5) Take Connector A on the wiring harness and
connect it to the external power connector on
your vehicle.
6) Connect the wiring harness connector to the
unit.
7) Install the unit in your car
8) Reconnect the ¤ battery.
9) Press the <Reset> button. (P.4)
10) Perform the Initial Setup.
See First Step (P.6).
24
ñ English
2
x1
[2]
4
x1
6
(3.5 m)
x1
8
(3 m)
x1
DNX7250DAB only
[1]
[2] Except DNX525DAB
x1
⿠DNX7250DAB, DNX5250BT,
DNX4250DAB, DNX4250BT
x1
x2
⿠DNX525DAB
x1
x1
Screws (included in
genuine audio unit)
✎
NOTE
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
Ñ Trim plate (DNX7250DAB, DNX5250BT,
DNX4250DAB, DNX4250BT)
1) Attach accessory 5 to the unit.
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it
in place.
5