Something Not Working - Zanussi Ideal IZTE 135 User Manual

Tumble Dryer

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red Start/Pause
the machine is not working.
Once the problem has been eliminated, press the Start/Pause
If after all checks, the problem persists, contact your local Service Centre.
Malfunction
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
16
Possible cause
• Mains plug is not plugged
in or fuse is not working cor-
rectly. • Loading door is open. •
Have you pressed the START/
PAUSE button?
• Wrong programme selected.
• Lint filter clogged. • Heat ex-
changer clogged with lint. •
Incorrect volume of laundry. •
Ventilation slots in base area
covered up. • Residue on in-
side surface of drum or drum
ribs. • Conductance of water
at installation site differs from
standard setting of machine.
• Fine strainer not in place
and/or large mesh filter not
locked in place.
pilot light flashes to indicate that
button to restart the programme.
Solution
• Plug in at mains socket.
Check fuse in fuse box (do-
mestic installation). • Close
loading door. • Press the
START/PAUSE
again.
• Select a different programme
the next time you dry (see
"Overview of programmes"
section).
• Clean lint filter.
• Clean heat exchanger.
• Observe recommended load-
ing volumes.
• Uncover ventilation slots in
base area.
• Clean inside surface of drum
and drum ribs
• Re-programme standard set-
ting for degree of drying (see
'Programming options' sec-
tion).
• Install fine strainer and/or
snap large mesh filter into
place.
button