Something Not Working; Heater Cut-Out - Zanussi TD163 Instruction Booklet

SOMETHING NOT WORKING
Before contacting your local Zanussi Service Force please carry out the following checks.
SYMPTOM SOLUTION
♦ The machine does not work/start
♦ Check that there is a supply of electricity
♦ Check the plug fuse
♦ Check the door is closed
♦ Check the machine is switched on
♦ Check the time selector dial is set correctly
♦ The clothes are not dry after normal
drying time
♦ Check you have used the correct temperature setting
♦ Check the vent hose is not blocked (sometimes a
strong wind may cause back pressure)
♦ Check the timer has not been set within a cool down
period
♦ The heater cut-out has operated. See below
♦ Check the lint filter is clean
If the tumble dryer does not function correctly after these checks, contact Zanussi Service Force.
IMPORTANT;
If you call out an engineer to a fault listed above, or to repair a fault caused by incorrect use
or installation, a charge will be made even if the appliance is under guarantee.
Heater Cut-Out
This cut-out operates if the airflow is severely
restricted. Before resetting it check:
4 The filter is clean.
♦
The air inlets at the back are not
blocked.
4 The exhaust venting is clear and not
kinked.
4 There are no other restrictions.
To reset the cut-out, press the red disk at the back
of the dryer.
If the cut-out continues to operate after checking
the above points you should contact Zanussi
Service Force.