Zanussi Ideal IZTE 135 User Manual page 17

Malfunction
When pressing a button,
the corresponding button
flashes several times.
Drying cycle ends shortly
after programme starts.
END light illuminated.
Programme inactive, Water
reservoir full light
illuminated.
Drying cycle lasts an
unusually long time.
Note: After around 5 hours
the drying cycle ends
automatically (see „Drying
cycle complete")
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service
Centre will require this information.
Possible cause
• Washing protection. After
the start of the programme,
the option can no longer be
set.
• Not enough washing loaded
or washing loaded is too dry
for selected programme.
• Condensate tank is full.
• Lint filter clogged.
• Heat exchanger clogged
with lint.
• DELICATE button pressed
and load volume too big.
• Load volume too big.
• Laundry insufficiently
predrained.
Important:
If you call out an engineer to a fault listed below,
or to repair a fault caused by incorrect use or
installation, a charge will be made even if the
appliance is under guarantee.
Tumble Dryer
Solution
• Turn the programme knob to
"0" Set the programme again
Select time programme or
higher drying level (e.g.
EXTRA DRY vinstead of
CUPBOARD ).
• Empty condensate tank, then
start programme with
START/PAUSE button.
• Clean lint filter
• Clean heat exchanger.
• DELICATE is only suitable
for use with loads of up to 3
kg!
• Reduce load volume.
• Laundry must be adequately
pre-drained.
17