Table of Contents
Advertisement
If the malfunction or fault code reappears con-
tact the Service Force Centre.
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a bluish coating on
glasses and dishes
Water drops have dries onto glasses and dishes
If after all these checks, the problem persists,
contact your local Service Force Centre.
Contact your local Service Force Centre, quot-
ing the model (Mod.), product number (PNC)
and serial number (S.N.). This information can
Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
20
The wash results are not satisfactory
• The wrong washing programme has been selected.
• The dishes are arranged in such a way as to stop
• The spray arms do not rotate freely due to incorrect
• The filters in the base of the washing compartment
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes;
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosing.
• Increase rinse aid dosing.
• The detergent may be the cause. Contact the de-
For other fault codes not described in the above
chart, please contact your Service Force Cen-
tre.
water reaching all parts of the surface. The baskets
must not be overloaded.
arrangement of the load.
are dirty or incorrectly positioned.
the salt container is empty or the incorrect level of
the water softener has been set.
tergent manufacturer's consumer care line.
be found on the rating plate located on the side
of the dishwasher door.. So that you always
have these numbers at hand, we recommend
you to make a note of them here:
Advertisement
Table of Contents
