Setting The Water Softener - Zanussi ZDT312 User Manual

Water hardness
Clarke
5 - 12
< 5
The water softener must be set in both ways:
manually, using the water hardness dial and
electronically.
Setting the water softener manually (see table)

Setting the water softener

electronically (see table)
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C until the lights of the func-
tion buttons A, B and C start flashing.
3. Press function button A, the lights function
buttons B and C turn off while the light of
function button A goes flashing, at the
same time the end of programme indica-
tor light starts to flash, along with a se-
quence of intermittent audible signals. The
current level is indicated by the number of
10
°TH mmol/l
7 - 18 0,7 - 1,8
< 7 < 0,7
Set switch to position 1 or
2
Adjusting the water hardness
setting
manually electronically
1
1
The water softener is factory set at position 2.
flashes of the end of programme indicator
light with a sequence of intermittent audible
signals and a pause of a few seconds.
Examples:
5 flashes / 5 intermittent audible signals,
pause,
5 flashes / 5 intermittent audible signals,
pause, etc...= level 5
6 flashes / 6 intermittent audible signals,
pause,
6 flashes / 6 intermittent audible signals,
pause, etc...= level 6
4. To change the level press the function but-
ton A. Each time button is pressed the level
changes (For the selection of a new level
see the chart).
Examples:
Use of salt
level 2 yes
level 1 no