Table of Contents
Advertisement
4. Make sure that the tip of the nozzle is dry, then remove a wax guard from the supplied
strip and place it on the tip of the nozzle, adhesive side down.
5. Place the sleeve on the earphone.
IMPORTANT: Do not place Wax Guards on sleeves! Wax guards are
intended for use on the tip of the earphone only, otherwise they will not
function properly.
SPECIFICATIONS
Transducer Type
Sensitivity (at 1kHz)
Impedance (at 1kHz)
Output Connector
Cable Length
Net Weight
FOAM SLEEVE
WAX GUARD
NOZZLE
FIGURE 2: E2c Wax Guard Installation
E1c
Low mass/
high energy
113.5 dB
SPL/mW
29
1.52 m
(60 inches)
17 g (0.6 oz)
ENGLISH
E2c
Dynamic
105 dB
SPL/mW
16
Gold-plated, 3.5 mm (
1.57m
(62 inches)
30 g (1 oz)
8
E5c
Dual low mass/
high energy
122 dB
SPL/mW
110
1
/
in.), stereo plug
8
1.55 m
(61 inches)
31 g (1.1 oz)
Advertisement
Table of Contents
