What To Do If - Zanussi ZVT 64 X Installation And Operating Instructions Manual

What to do if ...

Problem
The cooking zones will not
switch on or are not function-
ing
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds
is lit
and number are displayed Electronics fault
If you are unable to remedy the problem by following the above sug-
gestions, please contact your local Service Force Centre.
14
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch off has
been triggered
The control panel is wholly or
partly covered by objects.
The cooking zone was only
on for a short time and is
therefore not hot
The On/Off sensor field has
been covered up, e.g. by a
cloth
Overheating protection for
the cooking zone has been
triggered
Automatic switch off has
been triggered
Remedy
Switch the appliance on
again.
Deactivate the child safety
device (See the section
"Child safety device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
Remove objects.
If the cooking zone is sup-
posed to be hot, call your lo-
cal Service Force Centre.
Do not place any objects on
the control panel
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance
from the electrical supply for
a few minutes (Take the fuse
out of the house's wiring sys-
tem)
If after switching on again,
is displayed again, call the
customer service department