Get Started; Set Time, Date And Temperature Units; Set Time Alarm - La Crosse Technology 308-146W Quick Setup Manual

GET STARTED

Step 1: Insert the included 5-volt AC power adapter into forecast station
and then into wall outlet.
Step 2: Insert 3 new AA batteries (not included) into the forecast station.
Observe the correct polarity.
Step 3: Insert 2 new AA batteries (not included) into the outdoor
transmitter. Observe the correct polarity. The red LED will flash when
transmitting.
Restart: If the outdoor temperature is not displayed after 3 minutes,
remove batteries from the station & transmitter for 15 minutes. Return to
Step 1 above.
ATOMIC SIGNAL SEARCH:
The LCD backlight and USB charging port will momentarily turn off while
the station searches for the atomic signal. After the initial search, this
station will only search for the atomic signal after midnight.

SET TIME, DATE AND TEMPERATURE UNITS

1. Hold button 1 (SET) to enter time set mode.
2. To adjust values press buttons 3 or 4 (+/RCC or -/ºC/ºF).
3. Press button 1 (SET) to confirm and move to the next item.
Settings order: 1. WWVB Reception, 2. Time Zone, 3. DST Indicator, 4.
12/24 Hour Time Format, 5. Hour, 6. Minutes, 7. Year, 8. Month, 9. Date
Press button 1 (SET) to exit, or wait 20 seconds without pressing buttons
to return to the normal time display.
FAHRENHEIT/CELSIUS
Press button 4 (-/ºC/ºF) to select Fahrenheit or Celsius temperature
display.

SET TIME ALARM

1. Hold button 2 (ALARM) to enter alarm time set mode.
2. To adjust ALARM TIME press buttons 3 or 4 (+/RCC or -/ºC/ºF).
3. Press button 2 (ALARM) to confirm adjustments and move to the
next item.
Alarm Time setting order: 1. Hours, 2. Minutes
308-146/308-146W www.lacrossetechnology.com/support Page | 2