Door Reversal - Zanussi FLD 1000 User Manual

Door reversal

The opening direction of the outer door on this
washing machine can be reversed. To carry out this
operation, proceed as follows:
1) Disengage the end of the opening stop (1)
from the door and turn it through 90° to
remove it from its seat (Fig. A).
2) Using a screwdriver, turn plastic plug (2)
through 90° to remove it from its seat (Fig. A).
3 ) Fit plug (2) in the hole left free by opening stop
(1 ) and turn it through 90° to lock it into place
(Fig. B).
4) Fit opening stop (1) into the hole from which
plug (2) was removed and turn it through 90°,
making sure that the latching tooth is facing
towards the right (Fig. B).
5) Remove the door by unscrewing the screws
securing it to the bottom hinge (3 - Fig. A).
6) Unscrew the two plastic screws (4 - Fig. A)
and fit them on the opposite side (4 - Fig. B).
7) Remove the catch hook (5 - Fig. A) by
inserting a screwdriver into the upper hole and
pushing downwards.
8) Remove plate (6) by inserting a screwdriver
into the bottom hole and pushing upwards
(Fig. A).
9) Refit the catch hook (5) and plate (6) on the
opposite sides.(Fig. B).
10) Remove the door catch (7) and plate (8) as
explained in paragraph 7.
11) Turn the door through 180°.
12) Refit the door catch (7) and plate (8), reversing
their position and pressing firmly to engage
the hook (Fig. B).
13) Fit the door onto the washing machine. Insert
the top pin first, then the bottom pin into the
hinge (3 - Fig. B); finally screw the hinge onto
the washing machine.
14) Check that the door is aligned with the
appliance. To do this, loosen screw (9 - Fig. B)
by a couple of turns and re-tighten when
alignment is correct.
15) Fit the flexible end of the door opening stop
into the location provided in the door (1 - Fig.
B).
Fitting a door panel
The door of this washing machine has mouldings to
allow fitting of a decorative panel (stainless steel
sheet, laminated plastic, wood, etc.) to match with
the existing kitchen units.
The dimensions of the panel must be as follows:
Width
Height
Maximum thickness
To fit the panel, remove the moulding by unscrewing
its fixing screws. Position the panel, then refit the
moulding, making sure that it comes into contact with
and firmly clamps the panel.
30
588 mm
588 mm
4 mm