Table of Contents
Advertisement
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread
after having inserted the small filter "A" supplied with
the machine.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply loosen
the fitting, rotate the hose and retighten the fitting,
making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to
purchase a new, longer hose specially designed for this
type of use.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge of a sink using the plastic
hose guide supplied with the machine. In this case,
make sure the end cannot come unhooked when the
machine is emptying.
This could be done by tying it to the tap with a piece of
string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least
60 cm above the ground.
Directly into a drain pipe at a height of not less than
60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated,
i.e. the inside diameter of the drain pipe must be larger
than the outside diameter of the drain hose.
The drain hose must not be kinked. Run it along the floor;
only the part near the drainage point must be raised.
Electrical connection
This machine is designed to operate on a
220-230 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation can
take the maximum load required (1.75 kW), also
taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer declines any responsibility
for damage or injury through failure to
comply with the above safety precaution.
58
A
P0003
P0022
P0023
In the event of replacing the electric cable,
please contact our nearest Service Centre.
P0021
Hide quick links:
Advertisement
Table of Contents
