Something Not Working - Zanussi FL 984 CN Installation And Instruction Manual

Problems which you can resolve yourself:
Problem
The machine does not start up:
The machine does not fill:
The machine fills then empties
immediately:
The machine does not empty and/or does
not spin:
There is water on the floor:
Unsatisfactory washing results:

Something not working

Possible cause
Check that the door is firmly closed.
Check that the machine is plugged in and that there
is power at the socket.
Check that the main fuse has not blown.
Check that the programme selector dial is
positioned correctly and pulled out.
Check that the water tap is open.
Check that water is coming out of the tap.
Check that the inlet hose is not squashed or kinked.
Check that the filter in the inlet hose is not blocked.
Check that the door is closed.
The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
Check that the drain hose is not squashed or kinked.
A gentle programme with anti-crease option
been performed.
Too much detergent or unsuitable detergent (creates
too much foam) has been used.
Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it is
damp.
Check that the drain hose is not damaged.
Too little detergent or unsuitable detergent has been
used.
Stubborn stains have not been treated prior to
washing.
The correct temperature or programme was not
selected.
has
69