Operating Sequence - Zanussi FL1018 Instruction Booklet

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the
ECO valve. Then run the cotton cycle 60°, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out the prewash, pour detergent
into the appropriate compartment marked
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
.
.
4. Select the desired programme
Turn the programme selector dial to the desired
position.
The light of the START/PAUSE button starts to flash.
5. Reduce eventually the spin speed or
select the NO SPIN option
Using the spin speed selector dial, reduce the spin
speed or select the NO SPIN option
6. Select the required option(s)
The light corresponding to the depressed button
illuminates.
When selecting AGUA EN LA CUBA (RINSE HOLD)
option the water of the last rinse is not emptied out,
to prevent the fabrics from creasing.
16
.
.