Cancelling A Programme; Programme Has Started; Start The Programme; At The End Of The Programme - Zanussi FL 1015 Instruction Booklet

7. Select the DELAY START
Before you start the programme, if you wish the
starting to be delayed, press the DELAY START
button repeatedly, to select the desired delay. The
relevant light illuminates.

8. Start the programme

To start the selected programme, press the
START/PAUSE button; the corresponding light stops
flashing.
The PRELAVADO/LAVADO (Prewash/Wash) light
illuminates.
The machine starts operating.
If you have chosen a delayed start, the machine will
begin the countdown.

9. Altering a programme

You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme.
The washing water remains in the tub.
Start the new programme by depressing the
START/PAUSE button.

10. Interrupting a programme

Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.

11. Cancelling a programme

Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
12. Opening the door after the

programme has started

First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open in 2 minutes, this means
that the machine is already heating, that the water
level is above the bottom edge of the door or that the
drum is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
selector dial to "O". After about 2 minutes the door can
be opened (pay attention to the water level and
temperature!).

13. At the end of the programme

The machine stops automatically.
The START-PAUSE pilot light goes out and the pilot
light FIN comes on. The door can be opened.
If the ANTI-ARRUGAS
has been selected, the phase light "FIN" (END) is on
and the door is locked to indicate that the water must
be emptied out before opening the door.
To do this first turn the programme selector dial to "O"
and then to drain programme
. The spin programme is performed at the
maximum speed. In order to avoid any creasing or
damage in synthetic, delicate and wool items, the
spin speed must be reduced by turning the spin
speed selector dial.
At the end of the programme turn the programme
selector dial to "O" to switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out another wash, close
the water tap. Leave the door open to prevent the
formation of mildew and unpleasant smells.
17
(RINSE HOLD) option
or spin programme