External Cleaning; Frost Precautions; Moving The Machine - Zanussi ZDS 101 User Manual

117995910en.qxp 25/07/2006
Remove filter A from the
base of the washing
compartment.

External cleaning

Clean the external surfaces of the machine and
control panel with a damp soft cloth. If
necessary use only neutral detergents. Never
use abrasive products, scouring pads or
solvent (acetone, trichloroethylene etc....).
Ensure that the seals around the door, the
detergent and rinse aid dispensers are cleaned
regularly with a damp cloth.
We recommend every 3 months to run a 65°C
wash programme without dishes using
detergent.
Prolonged periods of non-operation
If you are not using the machine for any period
of time you are advised to:
1. Unplug the appliance and then turn off the
water.
2. Leave the door ajar to prevent the formation
of any unpleasant smells.
3. Leave the inside of the machine clean.
14
8.57 Page 14
IMPORTANT!
NEVER try to remove the spray arms.
If residues of soil have clogged the holes in the
upper spray arm, remove them with a
toothpick.
Replace the filters and
lock by turning the
handle clockwise to the
stop.

Frost precautions

Avoid placing the machine in a location where
the temperature is below 0°C. If this is
unavoidable, empty the machine, close the
appliance door, disconnect the water inlet pipe
and empty it.

Moving the machine

If you have to move the machine (moving
house etc....):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge
4. Pull the machine out together with the
5. Only transport the dishwasher in an upright
hoses.
hoses.
position, otherwise salt water may run out.