117995910en.qxp
25/07/2006
WARNING!
Multi-way plugs, connectors and extension
●
cables must not be used. This could
constitute a fire hazard through overheating.
If necessary, have the domestic wiring
●
system socket replaced. In case that the
electrical cable has to be replaced, contact
your local Service Force centre.
The plug must be accessible after the
●
appliance has been installed.
Never unplug the appliance by pulling on the
●
cable. Always pull the plug.
Fitting under a counter
By removing the dishwasher's worktop, you
can install it under a close fitting sink unit or a
pre-existing top.
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly levelled,
the door will not catch on either side of the
cabinet.
8.57
Page 21
Unscrew the two screws
Push the top backwards
at the rear.
about 1 cm.
Check if the dishwasher
is levelled.
Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is required.
Lift top at the front and
remove it.
If not, loosen or tighten
the adjustable feet until
the appliance is
perfectly levelled.
21