Vax VCW-02 Instruction Manual page 6

Vax VCW-02
Turn ON/OFF switch to the "ON" position (Fig.5/2).
Fig.5/2
Hold the tool approximately 1" above the stained surface.
Press the solution dispense trigger to apply cleaning
solution to the stained area. NOTE: Before using hand
tool attachments, it is necessary to prime the pump.
Follow these steps for optimal performance: (Fig.5/3)
• Fill the clean water tank.
• Place hand tool attachment on floor.
• Depress the solution dispense button on hose for
10 seconds while the power is off.
• Repeat if necessary.
Fig.5/3
Gently scrub the stained area with the brush on the tool
until the stain is completely removed. Release the
solution dispense trigger and continue moving the tool
over cleaned area to remove as much liquid as possible
(Fig.5/4).
6
usage
Fig.5/4
Emptying and Cleaning the Dirty Water Tank
WARNING: To reduce risk of electric shock
!
or injury, unplug before removing tank(s) and
remove tanks from unit before emptying.
When to empty:
– Dirty water reaches the 'full' line on the dirty water
tank - OR
– Float shuts off airflow, indicated by a change in pitch
of the motor and reduced suction
– At the end of each use, prior to storage
Turn ON/OFF switch to the OFF position. Unplug power
cord from outlet. Press down on the Lid Release Latch
and tilt towards the front of cleaner to access the tanks
(Fig.5/5).
Fig.5/5
LID RELEASE
LATCH